If you access a set, you do not have to obtain a special alligator clip for each individual case. In this way, conductive areas are exposed вЂ“ a source of danger for the users.ДЄn alligator clip set covers many possible uses for which alligator clips are intended.

If higher currents flow during use for a longer period of time, the insulation of the terminal could be destroyed by the high heating of the metal parts. This specification is particularly important for high currents from the single-digit ampere range for safe operation. The specified nominal current describes the current for which the alligator clip is designed. For example, for a cable with a diameter of two millimeters, a clamping range of four millimeters or more is sufficient for a secure hold. This should always be larger than the dimensions of the connecting parts to be measured, in order to ensure a secure connection without slipping of the terminal. The maximum clamping range is usually specified in millimeters and describes the maximum distance of the opening. For a permanent contact, you should solder the components, but a solder connection cannot be removed without leaving any residue. Stainless Steel flux is recommended for solder. Alligator clips are only designed for a short-term connection. Miniature Alligator Clips Mueller Electric Co Miniature Alligator with Barrel Images Drawings Miniature Alligator Clips Miniature Alligator Clips Models BU-30, BU-30C and BU-30X Mueller Electric Co Solder or crimp connection. The connection can be quickly loosened without leaving any residue.

However, the difference between the testing and transmitting alligator clips is not exactly defined, theoretically both larger and smaller clamps can fulfill both functions. On the other hand, smaller alligator clips are used for testing. In most cases larger terminals are used, which are also designed for significantly higher currents. Alligator clips are used not only for measuring electrical values such as voltage, current or resistance, but also for transmitting currents. The points to be tested may be wires or component connections to resistors, capacitors and other electrical components. This ensures a stable hold between the terminal and the test site.

They can be attached to test leads and are used for secure connection.

Miniature alligator clipt